AKKON - For 07-13 Sierra 1500 07-14 Sierra 2500HD 3500HD Headlights Front Lamps Direct Replacement Left + Right

Exactly what I was looking for and it was a great price and great match with the other one so I only had to install one

They don't make it easy to get to the bolts holding on headlight assemblies but watching a few YouTube videos got me going just fine. I reused the wiring harness and bulbs from my old assembly which was very easy to do. 2009 GMC Sierra 2500HDThese replacement headlight assemblies look fantastic and makes the truck look new again.

Looking to replace faded headlights for 2012 GMC sierra and this fit the bill. Do your research to ensure you get correct match. Look at description AND photos when purchasing. Prices beat all local prices and doorstep delivery from Amazon made it worthwhile

Fit beautiful but will make your headlights a little dim but if you use LED headlights it’s not too bad

Arrived as expected - they make my 2011 GMC look brand new. I read many reviews about aftermarket headlights and used exterior silicone to seal between the lens and the housing and have had no leaks (even taken them through high-pressure car wash) or condensation issues.

So.. had to replace some 2008 sun aged yellowing headlights and during my search came across these.. kinda liked the darker surround than my factory ones had and to me they better match the grill bumper combo. Was going to try the restore kits but then read an article that spoke about the percentage is improvement vs replacement and couldn't justify the safety margin when it came to hauling around the family.Now getting the old ones out was a pain, I had to pull the wheel liner out at the corner just enough to get my arm up there to loosen the bolt holding the back. Take the shroud of the radiator. Loosen the top of the grill and pull it forward. And pry the plastic surround from the top of the bumper because it holds onto the bottom of the lights in two places forward and the push it under the locking brackets of the light to free the assembly from the truck.With the old ones out I removed the wiring harness and bulbs and placed them in the new assemblies. Did a quick test and everything worked as expected. The reinstall process was definitely quicker.So.. problems that I found. The high beams bulbs installed at a different position than factory so I had to cut the factory tape holding them to gain a little more movement in the wires. I also note that one of the screws holding the retaining plate for the high beam bulb was loose and when I tried to tighten it it was stripped out in the caring so the screw couldn't get a good grab, don't think it's going to cause any issues though..Did I mention it looks amazing compared to the factory? To me it does and I'm glad I ordered these.Hope this helps.

They look and function awesome. I had one leak water and they sent me out a replacement set within a week. Great customer support,MAKE SURE TO ADD A LAYER OF SEALANT BEFORE INSTALL TO PREVENT FOGGING!

Build quality is...uh..off? Some modifications were required to allow installation of the bulb and wiring. I had to modify both housings to accept the lowbeam...removing the bulb retainer ring, re-drilling the hole, and re-attaching the ring (using the same screws) to allow me to install the headlight bulbs in a position similar OEM; OEM wiring loom doesn't have enough slack to allow much deviation. No biggie for me... but for others (such as my wife) would have likely meant a returned product. Definately not plug-n-play...but moding is easy if you're handy. Looks awesome once installed.