Gikfun20W Qi Charger Module Coil Car Fast Charging DIY Charger Parts Universal Type-C Interface EK1984
Details
- BrandGikfun
- Connectivity TechnologyInterface
- Connector TypeUSB Type C
- Compatible DevicesCellular
- Included ComponentsVHS
- Special FeatureFast Charging
Description
⚡ Charge smarter, not harder — power your hustle wirelessly!
- SLEEK COMPACT DESIGN - Ultrathin and lightweight module fits effortlessly into any custom charging setup.
- SMART SAFETY MANAGEMENT - Built-in MCU and IC chip prevent overloads with short-circuit and over-voltage protection.
- UNIVERSAL TYPE C INTERFACE - Seamlessly integrates with modern devices and DIY projects for ultimate compatibility.
- OPTIMIZED CHARGING DISTANCE - Efficient power transfer up to 8mm ensures convenience without compromising speed.
- LIGHTNING FAST 20 W WIRELESS POWER - Experience rapid Qi-standard charging that keeps you ahead in the fast lane.
The Gikfun 20W Qi Charger Module Coil is a universal wireless charging component featuring a Type-C interface and built-in MCU for intelligent charge management. Supporting up to 20W fast charging with multi-level safety protections, it delivers efficient Qi-standard power transfer within an 8mm range, all in an ultrathin, lightweight design ideal for DIY and professional use.
Reviews
J**G
Versatile, and work very well.
This works surprisingly well. I used this to create a phone charging pocket in my Jeep Gladiator.
M**W
Good, but not good enough
I'm making custom 3D printer chargers for family and friends. And despite making several modifications to my design, I could never get this to work when it was behind a 2mm sheet of 3D printer PLA. It would do most phones without a cover, but almost none with a cover. Just not enough power or surface. I ended up going with a dual coil charger and it has yet to NOT charge any phone.
S**K
Good
Works
E**T
decent quality
it works with my pixel 6 pro. It has 2 leds red for standby and green for charging they are a little too bright but it works well on my 3d printed phone holder
K**K
Worked as described
Measurements were accurate, working as hoped. Be aware, tolerance between phone and disk is VRRY small/tight but charging fine.
M**E
Ford F-150 Wireless Add-On
Installed this on the underside of the front center seat back next to the cupholders on a 2022 Ford F-150 XLT where the phone-shaped indentation is. Ran a usb-c cable to the rear port, and voila! No permanent modification needed, and wireless charging added for under $20. Took about 10 minutes.Will update over time if heat dissipation becomes an issue...
P**E
Not 20 watts
First off, the label on the unit I received shows that this item is not new, but a return, sold as new. 2nd, the highest wattage output I could get out of it was 5.6w. No where near the 20 watts it advertises. And yes... I used the proper cabling/charge adapters.
F**
It works
It works. I just wish the wires between the board and the coil were longer.
Common Questions
Trustpilot
1 week ago
1 week ago
Get the App
