Rugged Ridge | Suspension Coil Spring Spacer Leveling Kit, Front, 0.75 inch | 18360.04 | Fits 2007-2018 Jeep Wrangler JK

The Rugged Ridge Suspension Coil Spring Spacer Leveling Kit is an absolute game-changer for off-road enthusiasts! This 0.75-inch front spacer leveling kit not only provides an aggressive stance but also enhances ground clearance. The quality construction ensures durability and reliability, even in rugged terrains. It's easy to install, making a noticeable difference in the vehicle's appearance and performance. Rugged Ridge once again delivers a top-quality product, perfect for leveling the front end of your vehicle without compromising on ride quality. Highly recommended for any adventure-seeker looking to upgrade their ride!

While installing this, I found a broken coil spring. After all my repairs and installing this kit, my Jeep sits level. Doesn't appear to affect my gas mileage adversely.

The spacers are easy to install yes, however the material used to make the spacers do not last the spacers are already broken and out of place. They’re complete garbage and not worth it.

easy too install - the pic with the tools is before, the pic without the tools is after. one would think adding 3/4 inch (2 centimeters) spacer would not make much of a difference, but call me crazy, as soon as I sat down in the driver seat, I felt the difference. Make sure you have the tools to do the job right, this was my second attempt because, you really need 2 jacks to get it done, and you want to do it with safety in mind, so take your time, use jackstands and block the rear tires, front and back.

Did the job of leveling my Jeep but more difficult to install than expected.

Easiest and least expensive way to get rid of the forward rake in your JK.

after i put on a winch and bumper the front rake was more than i could tolerate.this took me back to stock maybe a little higher. for the price and ease of installation. great deal

The Both Spacers are splitting, one had a section completely crack and fall out. I found it on floor of the garage. Had been in the Jeep for only 1 month.

Justo lo necesario para nivelar todo el Jeep después de instalar un lift Mopar 2.5

INSTRUCTIONS:Jack up ONLY one side at a time -- loose the tire, jack up axle until the tire is off the ground - maybe 3 inches space under tire. must use a floor jackPut a jack stand under the frame.Remove the wheelremove the sway bar link bolt, remove the brake line bracket (i think it was on the passenger side only).remove the lower shock boltLower the axle as low as you can with the floor jack - watch for brake linesNow the spring should be loose. Pull it outremove the rubber spacer at the top, maybe stuck to the jeep still.Put the spacer above the rubber spacer.reinstall spring - you may need a pry bar on the bottom of the springjack up the axle levelreattach shock, link bolt, brake line bracketput on wheeljack up to remove the jackstandlower jack, begin same procedure on other side

ランクル300につけましたが、付けて半年で千切れて消えました。無駄な落下物を金払ってかうだけです。

Added a steel bumper + winch to my jeep and ended up with a sag. Used this spacer to counter that problem. I see noticeable from behind steering wheel (even for 0.75 inch spacer).

WORKED GREAT