OZ-USA REAR Red LED 1156 Bulb Compatible with Harley Touring Rear Turn Signal Road King Glide Electra Ultra

These are nicer and fit better then other wafer type led lites I've used. I hope they last. I installed these on rear of a 2001 flhtcui with red lens. No issue, they worked perfectly. The wafer had 2 round cut outs for screw post as well as square notch to align on the square key casting inside housing. Only thing I felt I had to do was hold wires down and add a blob of silicon over wires and to the back of waffer to provide wire support. Other type of wafer lites I've should had no support, so wire would break at the wafer from vibrations, also had no square notch. Only one day, so far so good. I'll update and change rating later if they don't hold up.

It is these or Custom Dynamics lights for $90. $15.00 just seems more reasonable. AND, they work great. When I received them, I felt like they were of questionable quality. The wires connected to the back of the circuit board were not anchored/epoxied in any way. The wire is a very small gauge, all that is required, but not durable to vibration and road bumps. It was very simple to use some clear epoxy to reinforce the wiring to board connection.Also, the bulb base connector that goes into the bulb socket to make the connection to the bike is painfully dangerous. The upper edge is curled out, bare and very sharp. When pressing the base connection into the socket and trying to twist turn lock the bulb base in place, IT HURTS LIKE H..L. If your bike light fixture socket has a strong spring to press against to lock the base in place, it will hurt even more. I corrected this problem with a 1/8" wide strip of duct tape (2 layers) around the sharp lip of the bulb/base connector to enable me to grip harder and not get gouged by the connector.But they were more than worth the extra effort. Really bright and quick responding to the turn signal voltage. Circuit boards fit perfectly in the light fixture. Mounted in a 2017 HD Road King.

Appreciably brighter than stock, worth the $$

Fit and finish is great. Super bright. Great for smoke lenses. If you replace front and rear you will need the load equalizer.

I'd ordered these up to go along with a custom dynamics load balancing smart triple play controller (get it - worth the coin) and had no issues with hyper flash etc. With the controller I got, I've got these running as tail lights, brake and turn signal, just right! Put them behind a light smoked lens and they look great. Perfect brightness, and easy install!

as advertised, fast delivery plug n play, u will have to get a load equalizer from Badlands to keep from hyper-flashing, for Harley Davidson its a plug n play, fixes both front and rear LEDs and tail brake light, from J&P catalogue

Works great

Item came perfectly packaged. Fit right on. Good quality at a reasonable price. However, I did receive a "light out indicator" (key light) on the dash of my 09 FLHR Road King. Needed to buy a separate resistor.

Easy install. Work great. Very bright. Interested in seeing how long they last. Wires are a bit flimsy but a dab of silicone to hold them down and stop any vibration hopefully make them last a long time.

For the price these leds are very good!

fonctionne tres bien mais comme signal sur ma motocyclette elle allume mais ne clignote pas le led ca prends une resistance pour fonctionner alors j ai fait une

very bright lights vs the old incandescent bulbs

good value