Flysky FS-GT2E AFHDS 2A 2.4ghz 2CH Radio System Transmitter for RC Car Boat with FS-A3 Receiver

Great Transmitter for the price! No problems and easy to set up! no problems and its working awesome!

Awesome. Brought an old rc car back to life. Great quality. Works better than the original.

It is a really good radio for the money when you need to add or replace a system in a car. Everything works as it should and all the basic adjustments you need. There are only two downfalls is it is slightly slower response rate/ resolution than high end radios and the status lights are blinding! The throttle resolution and steering is a little slower and linear than my better quality radios but to be fair those are 8-10x more expensive than this so it is understandable. The lights can be calmed down by putting a few layers of masking tape or using a sharpie to dull them down but you will get blinded by them at least once when setting up the radio with dulling them down! It is a really good radio for the money and I will surely get another when needed.

Perfect ! Installed it in my boat and off we went. Great price !!!!

Bought this to replace a failed transmitter/receiver in my truggy. Extremely cheap and fantastic range. The transmitter\receiver comes binded out of the box, so all I needed to do was swap out the receiver on my truggy, connect the wires and I was off to the races, literally. Total time from out of the box to functioning truggy was less then five minutes. No problem with range, which really surprised me with such an inexpensive transmitter\receiver bundle.If you are looking to replace broken or obsolete electronics for your rc car, give this one a shot. You will not be disappointed.

I purchased this to control a Tamiya buggy. Great value for the money and works fine. The grip is comfortable and the control is good.

Normally flysky is amazing this one came with a burned out receiver. No big deal, 10 bucks later, I had another receiver, but still annoying.

If you're using this for older flysky gt2 rx you have to switch modes. Section 6 of the manual. Emailed support to find out since I didnt read the manual...